One tea-bag study reported billions of plastic particles in a cup. Other recent studies report thousands, or flag a few thousand fluorescent features in a filter. Those figures look like direct contradictions, but the studies are not measuring the same size range, material, or kind of particle. The important question is not which headline number wins. It is what each method can actually identify, and whether its result applies to the tea bag in your cupboard.
A July 2026 discussion on r/Biohackers revisited the familiar “11.6 billion” claim and asked whether it described paper bags too. The short answer is no: it came from a small experiment on plastic bags. But later studies still find measurable particles from some tea bags, so the broader question remains worth examining.
What a particle count does and does not tell us
Microplastic is a label for small plastic particles, but studies do not all use the same size limits or identification tests. A microscope can reveal small objects. A fluorescent dye can make candidate particles easier to find. Spectroscopy can help identify a polymer by its chemical signature. Some studies combine these steps; others count features retained on a filter and identify only a subset of them.
That distinction matters. A count of fluorescent features is not automatically a count of individually confirmed plastic particles. A method that can see objects below one micrometre will return a different number from one that counts only larger particles. Mass is another measure entirely. More particles do not necessarily mean more plastic by weight, and none of these measurements alone establishes a health effect.
The type of tea bag matters too. Mesh, paper fibers, coatings, heat-sealed seams, and strings may use different materials. A pyramid tea bag can be made from plastic mesh, while some flat bags use paper-like fibers or composite materials. A label or appearance alone may not describe every component. That is one reason tea packaging science is relevant to interpreting these experiments.
Where the billions-per-cup figure came from
Hernandez and colleagues’ 2019 study examined four commercial plastic tea bags. The researchers emptied and rinsed the bags, steeped them in water at 95°C, then evaporated part of the infusion onto a surface for scanning electron microscopy. Their calculations produced an estimate of about 11.6 billion microplastic particles and 3.1 billion nanoplastic particles from one bag under those experimental conditions.
The result was striking, but it came from a narrow setup: four plastic bags, a specific preparation method, and an extremely small lower size threshold. It was not a survey of paper bags or a measurement of every tea sold. The study also did not test whether the reported particle count caused harm to people.
The German Federal Institute for Risk Assessment (BfR) later challenged the sample-preparation method. It said drying the infusion before microscopy could leave dissolved substances behind that look like particles, and that the study did not identify each counted object individually. In its own experiments, the BfR found substantially fewer particles larger than one micrometre and said many of the original study’s counts could be soluble plastic oligomers rather than microplastics. The original researchers responded to the criticism, so the 2019 result should be described as disputed, not treated as a settled measurement or simply erased.
What newer studies add
A 2026 Scientific Reports screening tested eight commercial products, including fiber and coated bags. Each was brewed at 95°C for ten minutes, with nine replicates. Researchers filtered the infusion through 0.7-micrometre-pore filters, counted Nile Red-positive features, tested selected features against polymer references, and used a model to estimate whole-bag counts and mass. The estimates ranged from 1,200 to 13,700 retained features and from 5.6 to 127 micrograms per bag. The authors reported spectra consistent with polypropylene for seven products; the highest result came from one PLA-coated paper bag. They cautioned that the study did not determine the source components or assess human health risk.
An October 2026 npj Science of Food paper used another approach. It compared 14 bagged teas with 14 bulk teas after a three-minute brew at 95°C and used ATR-FTIR to characterize particles. The authors reported 555 to 2,498 particles per cup for the tested plastic bags, compared with 0.3 to 2.4 in bulk tea. Bag particles larger than 100 micrometres consisted of polyamide fibers. These figures describe that study’s products, size range, and test conditions; they cannot be compared one-for-one with a method counting much smaller features.
A separate 2026 nylon-bag study used optical coherence tomography and reported 16,000 to 24,000 particles per millilitre for two measured size classes after five minutes in 100°C water. Its unit is a concentration, not a per-cup total. Again, the method and size cutoff differ. A systematic review of 19 direct tea-bag release studies found that material, temperature, steeping duration, agitation, and analytical method all affect reported results. It also identified a lack of standardized detection and quantification methods as a major obstacle to comparing studies.
Does this establish a health risk?
No. These experiments measure particles under laboratory brewing conditions. They do not show that a specific cup causes disease, measure long-term exposure in tea drinkers, or establish how much of each measured material is absorbed. The FDA says current scientific evidence does not demonstrate that the levels of microplastics or nanoplastics detected in foods pose a human health risk, while noting that research and measurement methods continue to develop.
That does not mean every bag material has been proven harmless. It means particle-release findings and health-risk findings answer separate questions. A paper-like bag that releases measurable material in one experiment is not proof that all paper bags behave alike, just as one plastic bag result cannot represent every product.
What tea drinkers can reasonably take away
If you want to avoid a bag’s material altogether, loose-leaf tea brewed in a metal tea infuser is one option. The evidence does not show that consumers need to stop drinking tea or that a particular alternative prevents a defined health outcome. For product-specific claims, look for the material used in the bag, coating, and seal, and be cautious when an article gives a large number without its test conditions or size threshold.
The best current conclusion is narrower than either headline: some tested bags release particles into water, and the measured amount varies widely with product and method. The 2019 billions figure is disputed, newer studies report different ranges, and current methods do not yet support a simple universal number for “a tea bag.”
Related Articles
- Tea Bags vs. Loose Leaf: Is There Actually a Quality Difference?
- The ‘Never Use Boiling Water for Green Tea’ Rule: Science or Tea Snobbery?
- Same Tea, Completely Different Cup: Why Gongfu and Western Brewing Produce Different Flavors
- Does Your Teapot Material Actually Change the Flavor? What the Science Says About Teaware
Related Terms
See Also
Research
- Hernandez, L. M., et al. (2019). Plastic teabags release billions of microparticles and nanoparticles into tea. Environmental Science & Technology, 53(21), 12300–12310. PubMed
- Summary: The original experiment behind the widely repeated count; it tested four plastic tea bags and used a preparation method later challenged by the BfR.
- Hernandez, L. M., et al. (2020). Response to comment on “Plastic teabags release billions of microparticles and nanoparticles into tea.” Environmental Science & Technology, 54(21), 14136–14137. PubMed
- Summary: The original research team’s published response to methodological criticism of the 2019 study.
- German Federal Institute for Risk Assessment. (2025, August 5). BfR assesses study on tea bags and microplastic particles. Official source
- Summary: Explains the concern that dried soluble material may have been counted as particles and summarizes the institute’s own measurements and health assessment.
- Yang, O., et al. (2026). Microplastic release from fiber and coated commercial tea bags: A fluorescence microscopy screening of eight products. Scientific Reports. Publisher
- Summary: Tests eight products at 95°C, describing the filter, fluorescent-feature counts, polymer checks, mass estimates, and limits of what the study established.
- Jayasekara, P. M., et al. (2026). Brewing plastics: OCT reveals microplastic release from nylon tea bags in simulated brewed tea infusions. Environmental Science: Processes & Impacts, 28(2), 392–404. DOI
- Summary: Provides a nylon-bag example using optical coherence tomography, different particle-size classes, and a per-millilitre concentration.
- Pehlivan, N., & Gedik, K. (2026). Microplastic release from plastic tea bags versus bulk tea and migration of bisphenol A and plasticizer esters. npj Science of Food. Publisher
- Summary: Compares bagged and bulk tea using a three-minute 95°C brew and reports particle counts under its own sampling and identification method.
- Sanei, M. E., Abedini, A., Khezerlou, A., et al. (2026). Tea bags as hidden source of micro- and nanoplastics: A systematic review for food safety. Current Research in Food Science, 12, 101425. PubMed
- Summary: Synthesizes 19 studies and identifies material, brewing conditions, inconsistent measurement methods, and health-risk uncertainty as key limits.
- U.S. Food and Drug Administration. (n.d.). Microplastics and nanoplastics in foods. Official source
- Summary: States that current evidence does not demonstrate a human health risk from levels detected in foods and notes ongoing scientific uncertainty.